BUILD YOUR OWN GLORYHOLE
BUILD YOUR OWN PRIVATE GLORYHOLE:
THE WORLD NEEDS MORE PRIVATE GLORYHOLES:
A door frame glory hole is as follows. This one is easy to build, quick to take
apart, sturdy and leaves very little evidence that you've been sucking dicks and
draining balls or anything has been done to your door frame.
1. Get a 5/8 inch piece of plywood. Particle board breaks apart to easy over
time and you want it to be thick enough that you won't have "play" when a guy
presses against it. That "play" can allow the whole door to be pushed in by
accident.
2. Measure your door frame to the inside of the door stop. The door stop is that
piece of wood that makes your door stop when you close it. Carefully cut the
plywood so that it fits inside of the door frame just like your door does.
3. Once the plywood fits into place, put a thin layer of duct tape or any sort
of tape to buffer the gloryhole door so that it doesn't scratch the paint on
your door frame.
4. After everything fits snuggly you will need to buy 4 to 6 Barrel bolts.
Take the barrel bolt (use a good long one) and mount it to the gloryhole wall on
the top, the middle and the bottom on the left and right sides. Then mark where
the bolt hits the door frame.
5. Next drill out holes in the frame the size of the bolts.
6. Now you can just open your door, put the glory hole wall in place and bolt it
inside of the door frame. It can quickly be set up and just as quickly taken
down. Then you can slide it under your bed or in your closet.
7. As for the hole itself. I used a CD to mark the hole. I simply stood the
gloryhole wall up an measured it for my own cock. I've seen huge holes and seen
small ones so the size is really up to you. When cutting the hole just do it
like you would any hole. Drill about 4 holes using a decent size drill bit at
North South East and West. Then use a jig saw to cut out the opening.
8. Be sure to sand all the edges real well and give it a few good coats of
paint. You don't want to get splinters in your cock when you play at the hole.
9. Hide the gloryhole under a Mattress or under a rug when you are not using it!
I hope this helps and I'd love to see some new gloryhole pics and videos when your new
gloryholes are done.
http://thegloryholes.blogspot.com
http://groups.yahoo.com/group/TheGloryHoles
I'm not sure I follow the part about the bolts; could you post pictures?
http://www.screwmaster.co.uk/brass-barrel-bolt-straight-38mm-6-p.asp
Sounds like these go on the left/right sides of the glory hole board, you open the door, place the glory hole board where the door normally goes and drill corresponding holes into the door jamb. When not in use and with the door closed, no one will see the holes that you drilled.
Just make sure you've got a long "throw" on the barrel bolts so the glory hole doesn't fall over if there's fucking going on and it gets energetic. That would kinda ruin the mood! :oops:
THE WORLD NEEDS MORE GLORYHOLES.